• Phone: 4169019387
  • Email us: info@windowfashionsdepot.com
  • Working Hours: 9:00 AM - 6:00 PM

Installation – Board-n-Batten

Mounting Instructions for Board-n-Batten Shutters
Printable PDF Version

  1. Lay the shutter face up on a clean, flat surface.
  2. Drill a 1/4” inch diameter hole through all horizontal rails, in center and 1 3/4” from each edge

Open Weave: Mark and drill at all vertical boards   SEE FIGURE #1

Closed Weave: Mark and drill only at the two outside vertical boards   SEE FIGURE #2

  1. Position the shutter on the house next to the window. Using a suitable marker, mark the mounting hole locations on the building.
  2. Remove the shutter and, where marked, drill a 1/4” inch diameter hole through the Wood, Vinyl or Aluminum siding only. *Do not drill into the wall*
  3. If the wall is Wood
  • Drill a 1/8” inch diameter hole, 1 3/4” deep into the wall.

If the wall is Masonry or Brick

  • For Masonry or Brick you will need a screw anchor for a #10 screw. The type of anchor purchased will determine the diameter of the hole. Follow the anchor manufacturer’s instructions for installation
  1. Position the shutter on the house next to the window and fasten with the metal screws provided.

*Be careful not to over tighten the metal screws or the shutter may become distorted*

*We suggest using a Hand Screw Driver rather than a Power Drill*

  1. Repeat this process for all remaining shutters.

FIGURE #1

FIGURE #2

Copyright of all materials on this website, including the underlying HTML, text, illustrations, designs, icons, audio clips, video clips, documents, products, software and all other content is owned by the Perfect Shutters.

The materials on the website;

  • The materials are not modified
  • Users exercise due diligence in ensuring the accuracy of the materials
  • The perfectshutters.com be identified as the source of the materials
  • The reproduction is not represented as an official version of the materials reproduced, nor as having been made in affiliation with or with the endorsement of the Perfect Shutters

Window Fashions Depot is a distributor of Perfect Shutters product line and represent the brand as a affiliate dealer 

All trademarks used and/or displayed on this website are registered or unregistered trademarks or official marks of Perfect Shutters.

Limitation of Liability

Under no circumstances, including, but not limited to, negligence shall the Window Fashions Depot be liable for any direct, indirect, special, punitive, incidental, or consequential damages arising out of the use of, or the inability to use, the website and/or the materials.

Thank you for using our website